clamAV upgrade error
Posted: 19 Feb 2011, 15:09
Hi,
Today I was unable to upgrade either MailScanner Script (2.79-> 2.80) or clamAV (v0.96.5 New:v0.97) from MailScanner FE GUI. Upon launching the upgrade, the scripts indicate that it is downloading the source files and then the page simply times out (in WHM). For the clamAV upgrade, this is the error I get in cpanel logs:
No specific error was reported during the MailScanner Script upgrade and I managed to upgrade the script from shell (/usr/src/msinstall /sh install.sh).
How can I get clamAv to upgrade properly?
I thank you in advance for your assistance.
Sebby
CentOS 5.5
WHM 11.28.83
Today I was unable to upgrade either MailScanner Script (2.79-> 2.80) or clamAV (v0.96.5 New:v0.97) from MailScanner FE GUI. Upon launching the upgrade, the scripts indicate that it is downloading the source files and then the page simply times out (in WHM). For the clamAV upgrade, this is the error I get in cpanel logs:
Code: Select all
2011-02-19 09:12:13 (1.12 MB/s) - `clamav-0.97.tar.gz' saved [41834871/41834871]
configure: line 2793: printf: write error: Broken pipe
make: *** No targets specified and no makefile found. Stop.
make: *** No rule to make target `install'. Stop.
replace: File '/usr/local/etc/clamd.conf' not found (Errcode: 2)
replace: File '/usr/local/etc/clamd.conf' not found (Errcode: 2)
replace: File '/usr/local/etc/clamd.conf' not found (Errcode: 2)
configure: WARNING: ****** bzip2 support disabled
config.status: error: cannot find input file: `clamconf/Makefile.in'
stdin: is not a ttyHow can I get clamAv to upgrade properly?
I thank you in advance for your assistance.
Sebby
CentOS 5.5
WHM 11.28.83